ZOLL AutoPulse Rev D Users Guide - Manual (Page 34)

Page 2-10 P/N 11440-001 Rev. 3
User Guide
The Battery is mechanically keyed so that it can only be inserted in one orientation. Do not force or slam
the Battery into the Battery compartment. If resistance is met, check for appropriate orientation, and
check to insure there are no obstructions to Battery insertion and that the Battery Latch is open.
Ensure that the Battery is securely latched (snaps into place) before moving the AutoPulse Platform or
initiating chest compression.
To remove the Battery, first rotate the Battery Latch into the open position as shown in Figure 2-11. Then
hold the AutoPulse Platform firmly and grip the Battery while pressing the finger latch upwards to
disengage the locking bar (see Figure 2-11), then pull the Battery straight out until it fully clears the
Battery compartment.
Caution: Only use ZOLL Batteries specifically designed for use with the AutoPulse. The use of other
batteries may cause permanent damage to the AutoPulse and will void the warranty.
2.3 Administrative Menu: User Pre-set Options
There are several options that may be pre-set by the user prior to deployment of the AutoPulse. These
options are:
• Compression mode
• Mute duration
• Tone volume
Additionally the Administrative Menu allows you to access the following information (refer to section
Section 3.7, “Viewing AutoPulse Platform Information,” on page 3-19):
• The last patient session
• The AutoPulse Platform
• The AutoPulse Battery