ZOLL AutoPulse Rev D Users Guide - Manual (Page 63)

P/N 11440-001 Rev. 3 Page 4-1
User Guide
4 Maintaining the AutoPulse System
4.1 Charging the Battery
For more information on the AutoPulse Power System and its components, refer to the AutoPulse Power
System User Guide.
To charge a Battery, follow these steps:
1. Slide the Battery into an available charging bay (see Figure 4-1). Make sure that the Battery locks
into place (locking bar engaged).
Caution: Remove the protective plastic cap from the Battery connector before attempting to charge
the Battery.
Note: For optimal charging, make sure that the Battery is at room temperature before insertion
into the Battery Charger.
Note: Do not slam the Battery into the Battery Charger because doing so may cause damage to
the Battery’s connector.
Note: The Battery is mechanically keyed so that it can only be inserted in one orientation. Do
not force the Battery into the charging bay. If resistance is met, check for appropriate
orientation, and check to ensure that there are no obstructions to Battery insertion.
Figure 4-1 Battery Charger with Charging Bay
2. The Battery Charger automatically detects the presence of an AutoPulse Battery.
3. The Battery Charger’s status will be indicated on the control panel (see Figure 4-2).