IEI Integration PPC-37xxA-N26 v1.10 - Manual (Page 38)

PPC-37xxA-N26 Panel PC
Page 22
Figure 3-3: PPC-3712A-N26 Back Cover Retention Screws
3.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the PPC-37xxA-N26.
Before the PPC-37xxA-N26 is installed, the jumpers must be set in accordance with the
desired configuration. The jumpers on the PPC-37xxA-N26 motherboard are listed in
7
Table 3-1 .