IEI Integration PPC-37xxA-N26 v1.10 - Manual (Page 68)

PPC-37xxA-N26 Panel PC
Page 52
Step 3: Insert the LAN cable RJ-45 connector . Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.
3.11.5 RS-232 Serial Ports
An RS-232 device can be connected to the RS-232 serial port on the bottom panel. To
install the RS-232 devices, follow the steps below.
Step 1: Locate the DB-9 connector . The locations of the DB-9 connectors are shown
in
7
Figure 1-4 .
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 3-43
.
Figure 3-43: RS-232 Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector
.
3.11.6 RS-422/485 Serial Port
To install the RS-422/485 device, follow the steps below.
Step 1: Locate the DB-9 connector . The location of the DB-9 connector is shown in
7
Figure 1-4 .