IEI Integration PPC-37xxA-N26 v1.10 - Manual (Page 63)

PPC-37xxA-N26 Panel PC
Page 47
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 100 mm interface pad. If the mounting arm is not
VESA compliant, it cannot be used to support the PPC-37xxA-N26
panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the
PPC-37xxA-N26 panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
PPC-37xxA-N26 panel PC. The arm mounting retention screw holes of the
PPC-37xxA-N26 panel PC are shown in Figure 3-37.
Figure 3-37: Arm Mounting Retention Screw Holes
Step 4: Secure the PPC-37xxA-N26 to the interface pad by inserting four retention
screws through the mounting arm interface pad and into the PPC-37xxA-N26
panel PC.