IEI Integration PPC-37xxA-N26 v1.10 - Manual (Page 62)

PPC-37xxA-N26 Panel PC
Page 46
Step 2: Slide the rear chassis through the rack/cabinet bracket until the rear side of the
LCD screen frame is flush against the front of the bracket.
Step 3: Make sure the retention screw holes at the rear of the LCD screen are aligned
with the retention screw holes in the rack/cabinet bracket.
Step 4: Secure the rack/cabinet bracket to the panel PC by inserting the retention
screws (Figure 3-36).
Figure 3-36: Securing the Rack/Cabinet Bracket
Step 5: Follow Step 4 and Step 5 of the PPC-3708A-N26 Cabinet and Rack Installation
procedures to complete the whole installation process. Step 0:
3.10.4 Arm Mounting
The PPC-37xxA-N26 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100 mm interface pad. To mount the PPC-37xxA-N26
on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.