IEI Integration PPC-37xxA-N26 v1.10 - Manual (Page 47)

PPC-37xxA-N26 Panel PC
Page 31
3.8.2 PPC-3710A-N26 HDD Installation
To install the HDD into the PPC-3710A-N26, please follow the steps below:
Step 1: Remove the back cover . See Section 3.5.
Step 2: Remove the HDD bracket from the PPC-3710A-N26 . The HDD bracket is
attached on the panel PC with four retention screws inside the chassis
(Figure 3-16). Remove the four retention screws and lift the bracket off the
panel PC.
Figure 3-16: PPC-3710A-N26 HDD Bracket Retention Screws
Step 3: Attach the hard drive in the bracket . To do this, slide the hard drive onto the
bracket until it connects with the SATA connector at the back. Fasten the four
retention screws on the sides (Figure 3-17).