Certifications and standards – Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" User Manual
Page 13
GP4000 Series Hardware Manual
13
Certifications and Standards
Note:
z
For information on the certifications and standards of the rear mount model, refer
to Certifications and Standards (see page 173).
Introduction
Pro-face submitted this product for independent testing and qualification by third-
party listing agencies. These agencies have certified this product as meeting the
following standards.
Agency Certifications
The GP unit is manufactured in accordance with:
z
UL 508 and CSA C22.2 n°142 for Industrial Control Equipment
z
Standard ANSI/ISA - 12.12.01 and CSA C22.2 n°213 for Electrical Equipment for
Use in Class I, Division 2 Hazardous Locations
Note:
z
For use in Pollution Degree 2 environments.
z
For use on a flat surface of a Type 1, Type 4X (Indoor Use Only) or Type 13
Enclosure.
z
24 Vdc input panel must be used with a Class 2 power supply.
z
Suitable for use in Class I, Division 2 Groups A, B, C, and D Hazardous
Locations.
Hazardous Substances
The GP is a device for use in factory systems. When using the GP in a system, the
system should comply with the following standards in regards to the installation
environment and handling:
z
WEEE, Directive 2012/19/EU
z
RoHS, Directive 2011/65/EU
z
RoHS China, Standard SJ/T 11363-2006
CE Markings
This product conforms to the necessary requirements of the following Directives for
applying the CE label:
z
2006/95/EC Low Voltage Directive
z
2004/108/EC EMC Directive
This conformity is based on compliance with EN61000-6-4, EN61000-6-2 (DC
model, AC model)
This conformity is based on compliance with EN60950-1 (AC model)
For information on Standards and Regulations, such as certified models and
certificates, see the following.
http://www.pro-face.com/worldwide.html