Renkus-Heinz IC32-R-II - Manual (Page 31)

At this point the changes you have made in beam steering have not been sent to the working memory (DSP) in the associated array or
stored as a Preset.
In the beam steering window, select either Send to Working Memory or Save to Preset. The two commands are in the lower right of the
beam steering window. Send to Working Memory will send the beam steering settings direct to the array’s DSP and write over any previous
settings. Save to Preset will store the beam settings in the designated Preset. Note that the Beam Steering Presets control only the beam
steering data; EQ, compression, etc. configuration settings are controlled in the Control Mode.
If you attempt to leave Beam Steering without saving the setup information, a prompt will remind you that you need to save the settings if
you want to keep them.
Note that Presets can not be saved to an array in the virtual world. Presets can only be saved to real loudspeaker via the network.
PRESETS
IC-R-II arrays can store up to 10 different configurations as Presets in the array’s DSP
memory. For example, you might optimize one configuration for small events on the main
audience area and another for larger occasions when a balcony is used. The Presets
include the beam steering data, as well as gain, EQ ,compression, etc. settings. Switching
between the preset configurations is easy. They can be changed from either the rear of the
array, from the controlling computer or, if one is provided a wall mounted remote control.
Third party controllers, such as those supplied by Crestron can also be used to configure
the array and select presets using the RS485 connection.
IC-R-II Arrays include the following factory installed Presets.
On single IC8-R-II arrays:
Preset 10: is factory installed and locked to “Flat” for use in transducer testing and should not be used during normal
operation.
Presets 11, 12, 13, 14, 15, 16, 17, 18 & 19 are set aside for user installed presets.
On all other IC-R-II arrays;
Preset 20: is factory installed and locked to “Flat” for use in transducer testing and should not be used during normal
operation.
Presets 21, 22, 23, 24, 25, 26, 27, 28 & 29 are set aside for user installed presets.
The digital readout on the rear of the array’s control panel displays the number of the selected Preset.
Users Manual IC-R-II
31
CONNECT