Renkus-Heinz IC32-R-II - Manual (Page 61)

61
Users Manual
IC-R-II
APPENDIX IV: KEEPING YOUR RHAON PROGRAM UP-TO-DATE
Updating DSP Firmware (Continued)
Step 3: Wait for the Firmware transfer to complete. When finished, control will be returned to the dialog window. Select “Done”.
Note: If you are installing the DSP Firmware into a multi module array, after you have updated the Master module disconnect the signal
cable from its normal connection to the Master (lower) module and insert it into the Primary Ethernet input on one of the Slave (upper)
modules. Then reset the dip switches on the Slave module to designate it as a Master (set it to 00) and set the original Master’s switches
to identify it as a Slave. Then proceed to update the 2nd module’s DSP Firmware just as you did for the lower module. If you have more
than two modules, repeat the procedure for each Slave module.
When the new DSP Firmware transfer is complete to all the modules, select Done. Then disconnect the signal cable from the upper mod-
ule and reconnect it to the lower module and reset its dip switches to their original Master (00) settings.
Please be aware that the Mutes and the Analog Input Pad will be On after the update is completed and may need to be reset.
GENERAL INFORMATION
Your Renkus-Heinz loudspeaker contains no user-serviceable parts and all service should be referred to qualified service personnel.
Hum and Noise Problems
If you encounter hum or noise problems in your system, please refer to the Loudspeaker User’s Manual that came with your loudspeaker,
Renkus-Heinz form RH 508 Rev B. It includes detailed instructions for locating the source of these problems and solving them.