Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 387)

Brocade Mobility RFS7000-GR CLI Reference Guide 373
53-1001945-01
Chapter
15
Standard ACL Instance
In this chapter
• Standard ACL Config Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 373
Use the (config-std-nacl) instance to configure ip access-list standard ACLs. Standard
ACLs allow filtering based on the source address only.
Standard ACL Config Commands
The following table summarizes config-std-nacl commands.
TABLE 11 Standard ACL config commands
Command Description Ref.
clrscr Clears the display screen. page 374
deny Specifies packets to reject. page 375
end Ends the current mode and changes to EXEC mode. page 376
exit Ends the current mode and moves to the previous mode. page 377
help Displays the interactive help system. page 378
mark Specifies packets to mark. page 379
no Negates a command or set its defaults. page 380
permit Specifies packets to forward. page 381
service Displays service commands. page 382
show Shows the running system information. page 383