Mobile-unit – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 528
514
Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
mobile-unit
Wireless Configuration Commands
Use this command to configure mobile unit related parameters.
Syntax
mobile-unit (association-history(clear|enable)|probe-history)
mobile-unit probe-history (add<1-200> <MAC Address>|enable)
Parameters
Example
RFS7000(config-wireless)#mobile-unit probe-history enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobile-unit association-history enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobile-unit probe-history add 20 AA-BB-CC-DD-EE-FF
RFS7000(config-wireless)#
association-history
Enables the mobile unit’s association history.
•
clear – Clears the association history for all mobile-units.
•
enable – Enables the mobile unit’s association history.
probe-history
Mobile unit probe logging configuration commands.
•
add <1-200> – Adds a mobile unit to probe history logging. Select an index
value between 1 to 200 to add probe logging MAC.
•
MAC Address – The MAC address of the mobile used for probe history
logging.
•
enable – Enables mobile unit probe logging.