Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 541)

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 527
53-1001945-01
Wireless Configuration Commands
20
dtim-period <1-50>
bss <1-4>
DTIM period (number of beacons between successive DTIMs)
•
<1-50> – DTIM period.
•
bss – BSS.
•
<1-4> – BSS index.
enforce-spec-mgmt (enable) Enforces spectrum management checks on specified radios. Only mobile units
that advertise spectrum management are allowed to associate to this radio.
enhanced-beacon-table Enables Enhanced beacon table for AP locationing.
enhanced-probe-table Enables Enhanced probe table for MU locationing.
group-id <1-256> Specifies the radio groups to balance user load.
•
<1-256> – A radio group identifier for this access-port.
location-message Specifies a message sent to mobile units associated with the radio. This message
must not exceed 80 characters.
mac (AA-BB-CC-DD-EE-FF) Changes the parent (access port) MAC address of the radio.
•
AA-BB-CC-DD-EE-FF – MAC address in AA-BB-CC-DD-EE-FF format.
max-mobile-units <1-256> Maximum number of mobile units allowed to associate.
mesh-associations<1-3> Specifies the number of client bridge mesh associations.
moto-simple-voice (enable) Brocade Simple Voice - use the WMM voice queue as a strict priority voice queue.
•
enable – Enables Brocade Simple Voice.
mu-power <0-20> Power adjustment level for mobile units associated with this access port. Mobile
units that support this element must reduce their transmit power by the specified
value.
•
<0-20> – Power in dBm.
nas-id (WORD) Configures a NAS-ID for this radio.
nas-port-id Configures a NAS-PORT-ID for this radio.
neighbor-smart-scan
[<1-4096>|<radio range>] Configures neighbor radios for smart scans.
•
<1-4096> – A single radio index.
•
<radio range> – A list (eg: 1,3,7) or range (eg: 3-7) of radio indices.
on-channel-scan Enables rogue scanning on this radio.
radio-numberr<0-3> Specifies the radio number inside AP. Enter 0 or omit when there is no ambiguity.
reset Resets a radio (this only resets the specified radio, not the complete access port).
reset-ap Resets the parent access port (this resets all radios on that access port).
rf-mode Configures radio speed based on 802.11 mode selected.
•
a – a only mode
•
an – a and n modes
•
b – b only mode
•
bg – b and g modes
•
bgn – b,g and n modes.
•
custom – custom
•
g – g only mode
•
n – n only mode
rts-threshold <0-2347> RTS threshold in bytes.
run-acs Runs Auto Channel Selection on a radio. The radio must already have been
configured for ACS.