Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 554)

540 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
show
Wireless Configuration Commands
Use this command to view current system information.
Syntax
show<parameter>
Parameters
Example
RFS7000(config-wireless)#show ?
access-banner Display Access Banner
access-list Internet Protocol (IP)
aclstats Show ACL Statistics information
audit-log-filters Display audit log filter rules
boot Display boot configuration.
clock Display system clock
commands Show command lists
crypto encryption module
crypto-error-log Display Crypto Error Log
crypto-log Display Crypto Log
debugging Debugging information outputs
dhcp DHCP Server Configuration
environment show environmental information
file Display filesystem information
fips-default-rules FIPS Default Rules ID
history Display the session command history
interfaces Interface status
ip Internet Protocol (IP)
ldap LDAP server
licenses Show any installed licenses
logging Show logging configuration and buffer
mac Internet Protocol (IP)
mac-address-table Display MAC address table
management Display L3 Managment Interface name
mobility Display Mobility parameters
ntp Network time protocol
password-encryption password encryption
port-channel Portchannel commands
privilege Show current privilege level
radius RADIUS configuration commands
redundancy-group Display redundancy group parameters
redundancy-history Display state transition history of the switch.
redundancy-members Display redundancy group members in detail
running-config Current Operating configuration
securitymgr Securitymgr parameters
sessions Display current active open connections
spanning-tree Display spanning tree information
startup-config Contents of startup configuration
static-channel-group static channel group membership
terminal Display terminal configuration parameters
timezone Display timezone
upgrade-status Display last image upgrade status
? Displays the parameters for which information can be viewed using the show
command.