Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 599)

Brocade Mobility RFS7000-GR CLI Reference Guide 585
53-1001945-01
SOLE Config Commands
22
locate
SOLE Config Commands
Use this command to invoke location commands.
Syntax
locate [aeroscout|ekahau |mobile-unit]
locate aeroscout [enable|interval <5-3600>]
locate ekahau [enable|interval <5-3600>]
locate mobile-unit [<AA-BB-CC-DD-EE-FF(enable)|enable|interval <5-3600>]
Parameters
Example
RFS7000(config-rtls-sole)#locate aeroscout enable
RFS7000(config-rtls-sole)#
RFS7000(config-rtls-sole)#locate ekahau interval 5
RFS7000(config-rtls-sole)#
aeroscout [enable|interval
<5-3600>] Locates aeroscout tags.
ekahau [enable|interval
<5-3600>] Locates ekahau tags.
mobile-unit[<AA-BB-CC-DD-
EE-FF|enable|interval
<5-3600>] Locates specified mobile-units.
•
AA-BB-CC-DD-EE-FF (enable)– MAC address of the mobile-unit.
enable Starts locating
|interval <5-3600> Configures location interval.
•
<5-3600> – Interval in seconds.