Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 542)

528 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
self-heal-offset <0-30> Configures the self healing offset, measured in dBm, for regulatory.
NOTE: This offset is based off the regulatory maximum power for the specified
channel (the command "show wireless regulatory" shows the max power
allowed).
short-gi (enable) Short GI value for both the 20 MHz and the 40 MHz channels for the 11n Radio.
•
enable – enables the capability.
short-preamble Enables short preamble support.
NOTE: Disables support for long preamble. Mobile Units that only support long
preamble will not be able to associate.
speed Configures the basic and supported data rates.
•
1 1-Mbps.
•
11 11-Mbps.
•
12 12-Mbps.
•
18 18-Mbps.
•
2 2-Mbps.
•
24 24-Mbps.
•
36 36-Mbps.
•
48 48-Mbps.
•
54 54-Mbps.
•
5.5 5.5-Mbps.
•
6 6-Mbps.
•
9 9-Mbps.
•
basic1 basic 1-Mbps.
•
basic11 basic 11-Mbps.
•
basic11a rate set (6,12,24 Mbps)
•
basic11an rate set (6,12,24, MCS 0-7)
•
basic11b1 rate set (1 and 2 Mbps)
•
basic11b2 rate set (1,2,5.5,11 Mbps)
•
basic11bg rate set (1,2,5.5,11,6,12,24 Mbps)
•
basic11bgn rate set (1,2,5.5,11,6,12,24, MCS 0-7)
•
basic11g rate set (6,12,24 Mbps)
•
basic11gn rate set (6,12,24, MCS 0-7)
•
basic11n rate set (MCS 0-7)
•
basic12 basic 12-Mbps.
•
basic18 basic 18-Mbps.
•
basic2 basic 2-Mbps.
•
basic24 basic 24-Mbps.
•
basic36 basic 36-Mbps.
•
basic48 basic 48-Mbps.
•
basic54 basic 54-Mbps.
•
basic5p5 basic 5.5-Mbps.
•
basic6 basic 6-Mbps.
•
basic9 basic 9-Mbps.
•
default Factory default rates based on radio type.
•
range All rates enabled, the lowest one set to basic.
•
throughput All rates basic (note: only g clients allowed on 11bg radios).