Service – Brocade Mobility RFS7000-GR Controller CLI Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 481
Brocade Mobility RFS7000-GR CLI Reference Guide
467
53-1001945-01
RADIUS Configuration Commands
19
service
Use this command to invoke RADIUS service commands. This command is used to enable the
RADIUS Server. A service RADIUS restart is executed only from the
config
mode.
Syntax
service (show) (cli)
Parameters
Example
RFS7000(config-radsrv-group)#service show cli
Radius user group configuration mode:
+-clrscr [clrscr]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-group
+-WORD [group WORD]
+-guest-group
+-enable [guest-group enable]
+-help [help]
+-no
+-policy
+-day [no policy day]
+-time [no policy time]
+-vlan [no policy vlan]
+-wlan
+-<1-256> [no policy wlan (all|.<1-256>) ]
.................................................................................
.................................................................................
.................................................................................
RFS7000(config-radsrv-group)#
show (cli)
Shows running system information.