Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 203)

Brocade Mobility Access Point System Reference Guide 193
53-1003100-01
5
FIGURE 90 Critical Resources screen - Adding a Critical Resource
6. Use the Offline Resource Detection drop-down menu to define how critical resource event
messages are generated. Options include Any and All. If selecting Any, an event is generated
when the state of any single critical resource changes. If selecting All, an event is generated
when the state of all monitored critical resources change.
Select the IP option (within the Monitor Via field at the top of the screen) to monitor a critical
resource directly (within the same subnet) using the provided critical resource IP address as a
network identifier.
7. Select the Interface option (within the Monitor Via field at the top of the screen) to monitor a
critical resource using either the critical resource’s VLAN, WWAN1 or PPPoE1 interface. If VLAN
is selected, a spinner control is enabled to define the destination VLAN ID used as the
interface for the critical resource.