Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 362)

352 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Refer to the following to determine whether a new Dynamic NAT configuration requires creation,
edit or deletion:
Select Add to create a new Dynamic NAT configuration, Edit to modify or override an existing
configuration or Delete to permanently remove a configuration.
FIGURE 192 Device Overrides - Security - NAT - Source ACL List screen
Source List ACL Lists an ACL to define the packet selection criteria for the NAT configuration. NAT is applied only on
packets which match a rule defined in the access-list. These addresses (once translated) are not
exposed to the outside world when the translation address is used to interact with the remote
destination.
Network Displays Inside or Outside NAT as the network direction for the dynamic NAT configuration.
Interface Lists the VLAN (from 1 - 4094) used as the communication medium between the source and
destination points within the NAT configuration.
Overload Type Options include NAT Pool, One Global Address and Interface IP Address. Interface IP Address is the
default setting.
NAT Pool Displays the name of an existing NAT pool used with the dynamic NAT configuration.
Overload IP If One Global IP Address is selected as the Overload Type, define an IP address used as a filter
address for the IP ACL rule.
ACL Precedence Lists the administrator assigned priority set for the listed source list ACL. The lower the value listed,
the higher the priority assigned to this ACL rule.