Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 446)

436 Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
Select Wireless.
Select Wireless LANs to display a high level display of existing WLANs.
Select the Add button to create an additional WLAN, or Edit to modify the properties of an existing
WLAN.
2. Select Auto Shutdown.
FIGURE 21 WLAN - Auto Shutdown screen
Refer to the following to configure Auto Shutdown parameters:
Select the + Add Row button to add time based access configuration for the WLAN.
Shutdown on Mesh Point
Loss Select to enable the WLAN to shutdown if the access point’s connection to the mesh network is lost.
This setting is disabled by default.
Shutdown on Primary Port
Link Loss Select to enable the WLAN to shutdown if the access point’s connection on its primary wired port is
lost. This setting is disabled by default.
Shutdown on Critical
Resource Down Select to enable the WLAN to shutdown if any one or all of the access point’s configured critical
resources are not reachable or available. This setting is disabled by default.
Shutdown on Unadoption Select to enable the WLAN to shutdown if the access point is unadopted from its wireless controller.
This setting is disabled by default.