Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 482
472
Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
19. Set the following Dynamic Sample Recovery parameters:
20. Select OK to update the Smart RF Neighbor Recovery settings. Select Reset to revert to the last
saved configuration.
21. Select the Interference Recovery tab.
FIGURE 36
SMART RF Recovery Configuration screen - Interference Recovery tab
Dynamic Sample Enabled
Select this option to enable dynamic sampling. Dynamic sampling enables an administrator to
define how Smart RF adjustments are triggered by locking retry and threshold values. This setting is
disabled by default.
Dynamic Sample Retries
Use the spinner control to set the number of retries (1 - 10) before a power change is allowed to
compensate for a potential coverage hole. The default setting is 3.
Dynamic Sample
Threshold
Use the spinner control to set the number of sample reports (1 - 30) used before dynamic sampling
is invoked for a potential power change adjustment. The default setting is 5.