Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 841)

Brocade Mobility Access Point System Reference Guide 831
53-1003100-01
13
Light intensity is measured by the sensor in lumens. The table displays the Current Light
Intensity (lumens) and a 20 Minute Average of Light Intensity (lumens). Compare these
two items to determine whether the deployment location remains consistently lit, as an
administrator can power off the access point’s radios when no activity is detected in the
immediate deployment area. For more information, see Environmental Sensor
Configuration on page 5-221.
5. Refer to the Light Intensity Trend Over Last Hour graph to assess the fluctuation in lighting over
the last hour. Use this graph to assess the deployment areas light intensity of particular hours
of the day as needed to conjunction with the daily graph immediately below it.
6. Refer to the Light Intensity Trend Over Last Day graph to assess whether lighting is consistent
across specific hours of the day. Use this information to help determine whether the AP8132
can be upgraded or powered off during specific hours of the day.
7. Select the Temperature tab.
FIGURE 92 Access Point - Environmental Sensor screen (Temperature tab)
8. Refer to the Temperature table to assess the sensor's detected temperature within the
AP8132’s immediate deployment area.