HT instruments FULLTEST3 - Manual (Page 62)

FULLTEST 3
EN - 61
6.1.2. CLEAR menu
In order to clear saved results the CLEAR menu shall be used.
TOTAL
CLEAR
LAST RESULT
Figure 49 : CLEAR menu
The whole memory (TOTAL) or only the last saved result (LAST RESULT) can be cleared. If the last
result is cleared, then the result saved before the last one become to be the last and can be cleared too
etc. Confirm clearing operation by pressing the YES touch-screen key.
6.1.3. USB menu
In order to transfer stored data to USB memory drive or to printer or to PC the USB menu shall be used.
Insert the USB drive into USB2 or USB3 slot then press the USB touch-screen key. Confirm transferring
by pressing the YES key.
6.2. SELECT OPERATOR menu
Figure 50 : OPERATOR menu
How to select wished operator:
- Check the list of available operators by using the ▼ and ▲ touch-screen keys (if there are more
than 4 operators entered).
- Select wished operator by pressing the operator’s touch-screen key, e.g. Default. Marked operator is
selected and will be used during the measurements.
- Press the ENTER touch-screen key to confirm the selection and to exit the OPERATOR menu, MAIN
MENU will be displayed again.
How to add a new operator:
- Open OPERATOR menu and press the ADD NEW touch-screen key, the following display will
appear.