In-Situ Win-Situ 2000 Operators Manual - Manual (Page 18)

14
0024690 rev. 002 09/00
4
SPECIAL ACTIONS
IN THIS SECTION . . .
• Choosing Measurement Units
• Setting the Device Clock
• Taking “Manual” Readings
• Setting a Device Name
• Configuring TROLLs, MP TROLLs, and HERMITs for
Telemetry/Network Communications
• Reloading Firmware
CHOOSING MEASUREMENT UNITS
Default units are used until you specify a choice of units. You can
always change the units later, when displaying data in Data Manager.
Unit preferences can be set at any time using the Options menu, and
are saved in the Site file.
1. Select Preferences from the Options menu.
2. In the Modify Unit Display Preferences window, click to select the
parameter whose unit you wish to change.
3. In the bottom half of the window, select the unit you want for the
highlighted measurement.
4. Repeat for another measurement and unit, or click OK.
TIP: Unit Display Preferences affect only the display of data,
not the data collected. To preserve unit selections for future
sessions, be sure to save the site when exiting Win-Situ.