In-Situ Win-Situ 2000 Operators Manual - Manual (Page 32)

28
0024690 rev. 002 09/00
9
TEST
OPERATIONS
IN THIS SECTION
• About Test Operations
• Starting a Test
• Stopping a Test
• Extracting and Viewing Data
• Deleting Tests
ABOUT TEST OPERATIONS
Test operations are initiated by action buttons in two places:
• the device’s Tests node, where information about all tests is
displayed and actions may be performed on multiple tests
• a single Test node, where actions are available for the selected test
The action buttons available depend on your test selection.
STARTING A MANUAL START TEST
1. Navigate to the device’s Tests node.
2. In the Information pane, select a pending manual test.
3. Select the action Start Test.
4. Click Yes to confirm your selection.
Once a test starts, the following actions will not be available:
Add Test, Delete Test(s), Edit Test, Set Device Clock, Edit
Device Info, Edit Parameter.