Thermo Fisher Scientific CyberScan PC 5000 User Manual
Page 13
Instruction Manual
CyberScan PC5500/ 5000
8
3.3 Conductivity
Probes
This meter allows you to use two types of conductivity cells: the 2-cell
conductivity cell with dual pin connector and the 4-cell conductivity
cell with DIN connector. If both a 2-cell and a 4-cell conductivity probe
are connected, the meter will read the 4-cell conductivity probe.
1. Carefully remove the protective
cover from the end of the
conductivity cell. Before using your
conductivity cell, soak it for 5 to 10
minutes in distilled or deionized
water.
2. Connect
the
2-cell conductivity cell to the 2-cell jack. Install the
ATC probe in the ATC jack.
OR
Connect the 4-cell conductivity cell to the 4-cell jack. The 4-cell
conductivity cells have built in ATC probes. Therefore, there is
no need to install a separate ATC probe.