Thermo Fisher Scientific Alpha pH 2000 - Manual (Page 27)

6 SET-UP MODE
6.1 Enter Setup mode
In the Setup mode the controller can be configured to your individual
requirements.
MEAS PH
O C
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
ENTER ENT
SETUP
HOL D
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
cur.1
SETUP
HOLD
cur.2
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
Temperature settings
see section 6.3
Relay A (set point 1) settings
see section 6.4
Relay B (set point 2) settings
see section 6.4
Controller settings
see section 6.5
Current output 1 settings
see section 6.6
Current output 2 settings
see section 6.7
Wash contact settings
see section 6.8
Unit settings
see section 6.9
Calibration
see section 5
CAL
1. While in Measurement mode press the ENT key.
2. The display prompts you to enter the security
code. Set the security code with
▲ or ▼ key to:
–“SCD22” if you want to change parameter settings
–“SCD000” if you want to view only parameter settings (view
only mode)
3. Press the ENT key.
Note: to exit Setup mode at any time press the ▲ and ▼ key
simultaneously (escape). The controller returns to the Measurement mode.