NORD Drivesystems BU0100 User Manual
Page 4
NORDAC SK 1xxE
4
Technical modifications observed
BU 0100 GB
SAFETY NOTES
Safe operation of the device requires that it is mounted and made operational by qualified personnel
according to the instructions provided in this manual.
Qualified personnel paying special attention to the safety and warning notes may only make adjustments.
Special attention must be paid to the general and regional installation and safety regulations for work on
high-voltage installations (e.g., EN, VDE) as well as to the directions for the proper use of tools and the
utilization of personal protection devices.
The motor connection terminals may carry dangerous voltage even at standstill of the motor (e.g., through
electronic lock [RUN] or blocked drive). A motor standstill is not equivalent to electrical disconnection from
system power.
ATTENTION:
Touching open or exposed terminals can lead to serious injuries or death! Always use
insulated screw drivers on these terminal panels. Make sure that the input voltage source is without voltage
before you make connections to the unit or prior to altering them.
ATTENTION:
The drive may start running immediately after applying system voltage.
1.1 Delivery
Inspect the device immediately after receipt/unpacking for transport damages such as deformed or loose parts.
In case of damage, contact the freight carrier without delay; initiate a careful fact-finding measure.
Important! This also applies if the packaging is not damaged.
1.2 European EMV (EMC) guideline.
If a NORDAC SK 1xxE is installed according to the recommendations of this manual, it will
meet all requirements of the EMC guideline being in conformity with the EMC product
standard EN60947-4-2 for low voltage switching devices, semiconductor control devices and
starters for alternating current..