Alto-Shaam COMBITOUCH MN-29245 - Manual (Page 6)

COMBITOUCH™ ES SERIES • ELECTRIC INSTALLATION MANUAL • 4.
THE OVEN MUST REMAIN ON
THE PALLET WHILE BEING
MOVED TO THE INSTALLATION
SITE BY FORK LIFT OR
PALLET LIFT TRUCK.
N O T E : Note dimensions required for doorways
and aisles for access of the oven and
pallet to the installation site. Transport
the oven in an upright and level position
only. Do not tilt the oven.
®
S I T E I N S T A L L A T I O N
I N S T A L L A T I O N
POSITIONING ON SITE
Lift the oven from the pallet with a fork lift or pallet
lift truck positioned at the front of the oven. For
damage protection, the use of two wooden boards,
placed between the bottom of the oven and the
lifting forks, is strongly recommended. To avoid
damage, position the lift forks to the left of the
condenser and right of the right leg as indicated in
the diagram above.
Stand the oven in a level position. Use the
adjustable feet to overcome an uneven floor and
ensure that the unit is level.
It is strongly recommended that table top models be
mounted on a factory supplied stand or a stand that
is stable, open, and level. Recommended height is
23-inches (584mm).
Adjust the height of floor models for smooth access
of the trolley or cart. When positioning the oven,
observe the minimum space allocation requirements
shown.
To insure proper operation, the installation of this
oven must be completed by qualified technicians in
accordance with the instructions provided in this
manual. Failure to follow the instructions provided
may result in damage to the oven, building, or
cause personal injury to personnel.
MINIMUM CLEARANCE REQUIREMENTS
L E F T S I D E
6" (152mm)
MINIMUM
18" (457mm)
SERVICE ACCESS RECOMMENDED
20" (508mm)
FROM HEAT PRODUCING EQUIPMENT
R I G H T S I D E
4" (102mm)
B A C K
4" (102mm)
FOR PLUMBING
T O P
20" (508mm)
FOR AIR MOVEMENT
NOTE:
Additional clearance is needed for service
access. A minimum distance of 18-inches is
strongly recommended. If adequate service
clearance is not provided, it will be necessary to
disconnect the gas, water, and drain to move the
oven with a fork lift for service access. Charges in
connection with inadequate service access is not
covered under warranty.
NOTE: To avoid equipment damage, observe
attention label on oven for area to avoid
with lifting fork.