Numerical setting-rotate, Select all, Numerical setting-rotate • select all – Brother PE-DESIGN Ver.432 User Manual
Page 101
91
NOTE:
The maximum value that can be entered is the largest value that will not allow the pattern to
exceed the size of the Design Page.
The minimum value is 1 mm (0.04 inch).
See also:
“Select System Unit” on page 103
■
Numerical Setting-Rotate
Purpose:
Rotates the selected pattern numerically.
Shortcut key:
No shortcut key for this function.
Toolbar:
No button for this function.
Operation:
1
Select one or more patterns. (Stage 3 only)
2
Click
Edit
, then
Numerical Setting
, then
Rotate
.
The
Rotate
dialog appears.
NOTE:
The range of values that can be entered is between 0 and 359 degrees, in 1-degree increments.
■
Select All
Purpose:
Selects all the data.
Shortcut key:
+
Toolbar:
No button for this function
Operation:
1
Click
Edit
, then
Select
All
(Stage 3 only).
◆
The desired rotation angle can be
entered by either typing in a value or
clicking the arrows to select the desired
value.
Select
0 degree
to leave the pattern
unchanged.
◆
Click
OK
to confirm.
◆
Click
Preview
to view the pattern
rotated the specified angle in the
Design Page.
◆
Click
Cancel
to exit without making any
changes.
Ctrl
E