Setting up, Attaching the security device, Attaching the security device 1 – Brother PE-DESIGN Ver.432 User Manual
Page 12
2
IMPORTANT: Be sure the PC is turned off before making any connection.
Attaching the Security Device
1
Attach the included Security Device to the computer’s printer port.
The application will not work if the Security Device is not properly attached.
◆
To make sure that the attached Printer Port is set to operate correctly, go to Windows - My Com-
puter – Control Panel – System – Device Manager.
If the settings are different from normal, follow the computer’s operation guide to change the set-
tings so that the Printer Port will operate correctly.
◆
The application will automatically search for the Security Device, even if the Printer Port is
expanded.
◆
If you are connecting a printer, scanner, etc., to the Printer Port, first connect the Security Device
so that it is closest to the computer, then connect the cable of the device.
◆
Even if you connect other printers or other devices after connecting this Security Device, the
device should operate with no troubles.
However, if the device does not operate correctly, use an open Printer Port or remove the Security
Device to use the other devices.
NOTE:
The devices listed below can not be used in the same Port with the Security Device.
SCSI interface for printer port
Printer Port connection type FDD
Printer Port connection type HDD
Printer Port connection type CD-ROM drive
Printer Port connection type ZIP drive
Printer Port communication Interlink or other network software
Others, data transmission devices that do not conform to Centronix printer interface standardized
specifications.
IMPORTANT:
When connecting the Security Device or connecting cables to the Security Device, be sure
to turn off the power of the computer and the connecting device.
Security Device connected to the computer
Setting Up