Brother PE-DESIGN Ver.432 - Manual (Page 90)

80
Bef
ore Using
Design Center
La
y
out & Editing
File Utility
Programmable
Stich Creator
Contents
Quik Ref
erence
Alphabetic Inde
x
Getting Star
ted
◆ New Figure
Opens a new Stage 3 Design Page.
Use this button when you want to create data from vector data from the beginning, or when you
want to create data from vector data taken from a previously saved PEM file.
For details, see File – “New Figure Data” (page 78).
◆ Cancel
Closes this dialog.
When Photo Stitch is selected
When you click the Photo Stitch button in the dialog above, the following dialog opens.
Position the mouse pointer over any button and the name of the action will display.
The functions for each button are described below.
◆ Open Photo File
Opens a previously saved image file and pastes it in the Design Page.
For details, see the section in File – “Open” (page 81).
◆ From TWAIN device
Import an image from a TWAIN device and paste it in the Design Page.
For details, see File – “Input from TWAIN device” (page 83).
◆ From Clipboard
Pastes an image from the clipboard in the Design page. This function can only be used when
there is an image on the clipboard.
For details, see File – “Input from Clipboard” (page 83).
◆ Use Current Photo
Use an image opened in Stage 1. This function can only be used when an image is opeded in
Stage 1.
◆ Previous
Closes the current dialog, and returns to the selection dialog from the previous step.
◆ Cancel
Closes this dialog.
If any button other than Previous/Cancel is clicked, the image importing operation will take place,
and the image will be pasted on the Stage 1 Design Page. After that, the Select Mask dialog for
creating Photo Stitch data will open.
For directions after that point, see Stage – “To Photo Stitch” (page 109).