Brother PE-DESIGN Ver.432 - Manual (Page 212)

202
Bef
ore Using
Design Center
La
y
out & Editing
File Utility
Programmable
Stich Creator
Contents
Quik Ref
erence
Alphabetic Inde
x
Getting Star
ted
Error Messages
The application is able to detect problems that may occur before or during data transfer. Here is the com-
plete list of error messages that may appear.
1 If the card module is not correctly connected:
2 If there is no card in the card module:
3 If an incorrect or defective card is inserted:
4 If a defect is detected after reading has already started, or if you remove the card while reading is
in progress, reading will stop and this message will display:
You should never remove a card while the red indicator light in on. If you do so, you will have to
restart the operation from the start.
If you did not remove the card and the above message appears, then the card is defective or was
not well inserted. Reinsert the card correctly and try reading again. If you get the same message,
then the card is defective. Try with another card.
◆ Correct the connection between the
card module and the computer.
Check that the module is powered.
◆ Click Retry to start reading.
◆ Click Cancel to exit.
◆ Insert a Embroidery card in the
module.
◆ Click Retry to start reading.
◆ Click Cancel to exit.
◆ Insert another Embroidery card in
the module.
◆ Click Retry to start reading.
◆ Click Cancel to exit.
◆ Click OK to remove the message.