Check the data, Check the data 1 – Brother PE-DESIGN Ver.432 User Manual
Page 60
51
The sewing order that you have set is optimized to reduce the number of times that the embroidery
frame installation position is changed.
•
When the Optimize hoop change setting is turned off:
Each pattern is sewn according to the sewing order that you have set. Therefore, since the number of
times for changing the embroidery frame installation position is not optimized, it may be changed
more often than if it was optimized.
NOTE:
Since the pattern may not be sewn correctly or the fabric may not feed evenly if the embroidery
frame installation position is changed too often, we recommend turning on the Optimize hoop
change setting. Since turning on this setting will change the sewing order that you have set, check
the sewing order before you begin embroidering.
■
Check the data
1
Click Option, then Design Property.
At the same time that the Design Property dialog appears, the Design Page is automatically
enlarged or shrunk to fit in the entire window.
NOTE:
If an object is larger than the embroidering area or if an object is positioned so that it does not
completely fit within an embroidering area, the error message “Please change the object size or
position.” is displayed instead of this dialog. After the object causing the error appears selected,
change its size or position. (If more than one object causes the error message to appear, the
objects will appear selected in the sewing order.)
NOTE:
Make sure that no pattern has been selected before clicking this command. If a pattern has been
already been selected, only the information for that pattern is displayed.
2
To preview the image, click Display, then Preview or click
on the Toolbar.
NOTE:
Just like for the command Option – Design Property, if an object is larger than the embroidering
area or if an object is positioned so that it does not completely fit within an embroidering area, the
error message “Please change the object size or position.” is displayed instead of displaying a pre-
view of the image. After the object causing the error appears selected, change its size or position.
◆
The first line of the dialog shows the
position in the embroidery frame instal-
lation order for the currently displayed
design.
•
Only the designs that would be sewn at
the current position in the embroidery
frame installation order appear in the
Design Page. In addition, the embroi-
dering area for the current frame instal-
lation position is outlined in red.
◆
Click Previous or Next to display infor-
mation for the designs at other posi-
tions in the embroidery frame
installation order.
•
At this time, the corresponding pattern
and embroidery frame position appear
in the Design Page.