Brother PE-DESIGN Ver.432 User Manual
Page 95
86
In Region Sewing Mode, the
Sewing Attribute Setting
dialog displays the
Region sewing
tab. Here
you can change the settings of the stitch selected in the
Region sew type
selector of the Sewing
Attributes bar. The other stitch settings display in gray.
Example of the
Sewing Attribute Setting
dialog for a Programmed Fill Stitch:
Running stitch
Run pitch
Sets the pitch of the line sewing (when
Running
Stitch
is selected for the outline).
Range: 1 ~ 10 mm (0.04 ~ 0.39 inch)
Default: 2 mm (0.08 inch)
Run times
Sets the number of times the border will be sewn (when
Running
Stitch
is
selected for the outline).
Range: 2, 4, 6
Default: 2
◆
Enter the desired values for each set-
ting either by clicking on the arrows or
by typing the value directly in the edit
box window.
•
When you click a selector, a preview
image of that setting displays.
The image will change and reflect your
setting changes each time you click an
arrow.
◆
To restore the default value of an indi-
vidual setting, click its
Default
button.
◆
Click the region(s) you want to apply
the selected settings to.
◆
Click
Close
to exit.
Region sewing attribute
Fill stitch, Satin stitch and Programmed fill stitch:
Under sewing
Sets under sewing on/off. Try to use Under sewing for wide areas, in
order to prevent shrinking during stitching. Depending on the shape
of the region, however, it may not be possible to make this setting.
Density
Sets the number of lines per mm.
Range: 1 ~ 7 lines per mm (25 ~ 178 lines per inch)
Default: 4.5 lines per mm (114 lines per inch)
Direction
Sets the direction of the stitch.
Range: 0 ~ 179 degrees
Default: 45 degrees
0˚
45˚
90˚
135˚
179˚