Brother PE-DESIGN Ver.6 - Manual (Page 20)

12
Before Use
[STEP 3] Upgrading the USB card writer module
This section describes how to upgrade the USB card writer module for version 6.0. Users upgrading from
version 5.0 or later must upgrade the card writer. After installing version 5.0 or later, immediately follow the
procedure below to upgrade the card writer for version 6.0.
1.
Start up Layout & Editing.
→ The dialog box shown below appears.
2. To begin the upgrade, click Upgrade now.
→ The Upgrade wizard starts up, and the
first dialog box shown below appears.
3. Click Next.
4.
Type in the 15-digit product ID on the label
attached to the CD-ROM case, and then click
Next.
→ The entered product ID and the serial
number automatically retrieved from the
USB card writer module is displayed.
5. Click Next to access our server through the
Internet and retrieve the upgrade key.
→ If the upgrade key has been successfully
retrieved, the dialog box shown below ap-
pears.
6.
Click Next to begin upgrading the USB card
writer module.
a
Note:
• If the USB card writer module is not upgraded, Design Center and Layout & Editing of version 6.0 can
no longer be used after the specified number of trial uses has been reached.
• In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you
cannot connect to the Internet, contact your nearest service representative.
PeDesignV6Eng.book Page 12 Thursday, July 8, 2004 11:59 AM