Brother PE-DESIGN Ver.6 - Manual (Page 204)

196
Layout & Editing
Saving and Printing
b
Memo:
Patterns created on a custom-sized Design
Page are written to cards split into their various
sections.
If the total size of the pattern exceeds the
capacity of the original card or if your Design
Page is set to a custom size of 90
×
90 cm (3.54”
×
3.54”), and is split into over 80 sections, you
will need to split the pattern into sections and
write them onto several original cards.
In this case, the Select Hoop Sections dialog
box appears to let you select the sections that
can be written in the available space on the card.
The progress bar at the top of the dialog box
shows the available space on the card as you
select pattern sections to be written to the card.
The space used by the selected pattern sections
appears in blue. If, however, you select a pattern
section that exceeds the size limit, the space
used appears in yellow, and if you select several
pattern sections which exceed the size limit, the
space used appears in red.
Click each pattern section to select it, and
then click Write to write the selected pattern
sections to the card. To deselect a pattern
section, simply click it again. (The Write
button is available only when a section is
selected and the space on the card is
sufficient to receive the selected patterns.)
3. Click OK.
→ The message “Now writing” appears while
the current embroidery pattern is trans-
ferred to the original card, and then the
following message appears.
b
Memo:
To quit the operation, click Cancel.
4.
Click OK to close the message.
b
Memo:
“Overwriting” on page 194 and “Saving with
a new name” on page 194
Writing multiple embroidery
files to an original card
You can save multiple .pes files to an original card
at the same time.
1.
Insert an original card into the USB card writer
module.
2.
Click File, then Write to Card, then Other
PES files.
→ The following dialog box appears with the
contents of the last folder accessed dis-
played in the available patterns list.
a
Note:
• The original card is inserted correctly
when you hear it snap into place.
• The sewing machine must be turned off
before original cards are inserted or
removed. However, it is not necessary to
turn off the computer when original cards
are inserted or removed from the USB
card writer module.
Available patterns Selected patterns
PeDesignV6Eng.book Page 196 Thursday, July 8, 2004 11:59 AM