Brother PE-DESIGN Ver.6 - Manual (Page 94)

86
Design Center
Stage 4 (Sew Setting Stage)
■
Applying sewing attributes to a
portion of the outline
1. Click on the Tool Box.
→ The shape of the pointer changes to
, and the Sewing Attributes bar ap-
pears similar to the one shown below.
2.
If necessary, change the color and sew type.
b
Memo:
• You can change the sew type either before
or after applying sewing attributes to the
portion of the outline. For more details on
changing this setting, refer to “Sew type”
on page 89.
• You can also use the settings in the
Sewing Attribute Setting dialog box to
define other attributes of the sew type. (For
more details, refer to “Specifying sewing
attributes” on page 89.) If you do not
change these settings at this time, the
current settings will be applied, however
you can modify them later.
3.
Click the portion of the outline where you want
to apply the sewing attributes.
→ “Marching lines” appear along the select-
ed portion of the outline, and the sew type
selected on the Sewing Attributes bar is
applied to the portion of the outline.
■
Checking the sewing attributes of
an outline
1. To check the attributes of the entire outline,
click on the Tool Box.
→ The shape of the pointer changes to
.
To check the attributes of a portion of the
outline, click on the Tool Box.
→ The shape of the pointer changes to
.
2.
Right-click the outline or a portion of the
outline.
a
Note:
The color cannot be set separately for a
portion of an outline. If you change the color,
the new color will be applied to the entire
outline of the portion that is clicked.
PeDesignV6Eng.book Page 86 Thursday, July 8, 2004 11:59 AM