Actiontec electronic GT701R - Manual (Page 22)

17
Setting up
Static IP Addresses
This chapter details how to set up the Modem with a static IP address. The first
section explains the configuration using a single static IP address; the second sec-
tion explains the configuration using a block of static IP addresses.
Configuring for a Single Static IP Address
To set up the Modem to use a single static IP address:
☞
Note: To complete this procedure, the Internet Service Provider
( ISP
) worksheet or welcome letter must be available to consult.
If no worksheet has been provided, contact the ISP .
1. Open the Web browser. In the “Address” text box type:
http://192.168.0.1
then press Enter on the keyboard.
2. The Qwest Home screen appears, set to the “Status” tab. Select Advanced
Setup from the row of tabs at the top.
☞
Note: If the Qwest Home screen does not appear, make sure the
Ethernet cable is properly connected to the Modem.
4