Actiontec electronic GT701R - Manual (Page 9)

4
Actiontec USB/Ethernet DSL Modem User Manual
5
Chapter 1 Introduction
Rear Panel
The rear panel of the Modem contains four ports (Phone, USB , Ethernet, and
Power), as well as a Power switch and Reset button.
Power
USB
Ethernet
Phone
Reset
Phone Port
The Phone port is used to connect a
DSL (Digital Subscriber Line) connection to
the Modem.
USB Port
The
USB port is used to connect a computer to the Modem via USB cable.
Ethernet Port
The Ethernet port is used to connect computers to the Modem via Ethernet
cable, and is a 10/100 Mbps port.
Reset Button
To restore the Modem’s factory default settings, depress and hold the Reset but-
ton for approximately 10 seconds, or until the Power light glows amber. The
reset process will start about
10 seconds after releasing the Reset button.
Power Switch
The Power switch turns the Modem on and off (on if the top part of the switch
is depressed, off if the bottom is depressed).