Actiontec electronic GT701R - Manual (Page 26)

20
Actiontec USB/Ethernet DSL Modem User Manual
21
Chapter 4 Setting up Static IP Addresses
Configuring for a Block of Static IP Addresses
To set up a the Modem to use a block of static IP addresses:
☞
Note: To complete this procedure, the Internet Service Provider
( ISP
) worksheet or welcome letter must be available to consult.
If no worksheet has been provided, contact the ISP .
1. Open the Web browser. In the “Address” text box type:
http://192.168.0.1
then press Enter on the keyboard.
2. The Home screen appears, set to the “Status” tab. Select Advanced Setup from
the row of tabs at the top of the screen
☞
Note: If the Home screen does not appear, make sure the
Ethernet cable is properly connected to the Modem.