Actiontec electronic GT701R - Manual (Page 60)

55
Troubleshooting
This chapter contains a list of problems that may be encountered while using the
Modem, and techniques to try and overcome the problem. Note that these tech-
niques may not solve the problem.
LAN Connection Failure
s
Ensure the Modem is properly installed, the LAN connections are installed
correctly, and the power is on.
s
Confirm the computer and Modem are on the same network segment. If
unsure, let the computer get the IP address automatically by initiating the
DHCP function (see “ DHCP Settings” on page 32), then verify the com-
puter is using an IP address within the default range (192.168.1.2 through
198.168.1.254). If the computer is not using an IP address within the range, it
will not connect to the Modem.
s
Ensure the subnet mask address is set to 255.255.255.0 by clicking Status in
the Modem GUI ’s Home screen.
Cannot Connect to the Internet
s
Ensure both ends of the power cord and all network cables are properly
connected.
s
Ensure the subnet mask address is set to 255.255.255.0 by clicking Status in
the Modem GUI ’s Home screen.
s
Verify the Modem’s settings are the same as the computer’s by clicking Status in
the Modem GUI ’s Home screen.
s
If running Windows 98 SE or Me, check the computer’s TCP / IP settings. Select
Start, Run, enter
winipcfg
in the “Open” text box, then press OK . The “ IP Configuration” window appears.
Ensure the text box at the top of the window contains the name of the Ethernet
adapter installed in the computer. If not, click on the down arrow next to the
text box. When the list appears, click on the appropriate Ethernet adapter.
In the fields below, the Ethernet adapter’s various addresses appear.
8