HP Integrity NonStop J-Series - Manual (Page 294)

APPENDIX B
ENABLE MESSAGES
This appendix lists error and warning messages that may be issued
in response to ENABLE commands during application generation, or
during execution of an ENABLE application.
Unless specifically noted as a warning, all messages are error
messages. Error messages signify that an error in processing has
occurred. A warning message signifies that a questionable
condition exists. These conditions are handled as follows:
ERROR ENABLE prefixes error messages with the label
"*** ERROR ***."
An ERROR is fatal to the operation being attempted; in
the case of a GENERATE command, ENABLE does not create a
PATHCOM command file, SCREEN COBOL source code, or
SCREEN COBOL object code.
If ENABLE is running in interactive mode, it issues a
prompt. If running in noninteractive mode, it
terminates.
WARNING ENABLE prefixes warning messages with the label
"*** WARNING ***."
A warning indicates a questionable condition that does
not halt processing of the requested application.
ENABLE calls the SCREEN COBOL compiler internally; therefore, you
could receive a message from the SCREEN COBOL compiler that is
not listed in this appendix. Refer to the SCREEN COBOL Reference
Manual for a list of SCREEN COBOL messages.
B-1