HP Officejet 590 All-in-One Printer - Manual (Page 33)

3/27/97 11:3 am Final version given to printer
...............................................................................................................
1-25
HP Company Confidential
1. Se
tting
Up
7. Install the Software -
REQUIRED!
You must install the software before using your new HP OfficeJet
Series 500 – if you don’t, the OfficeJet won’t work.
Important: If you don’t have a CD-ROM disc drive, please call the
HP OfficeJet Fulfillment Center at 1-888-HPDISKS
(1-888-473-4757) to receive the software on 3.5-inch floppy diskettes
by overnight mail.
1. Turn on your computer. Or, if you did not turn off your computer
previously in Step 3, restart your computer now.
2. This step has two different sets of instructions: one for Windows
95 users, and one for Windows 3.1 users. Use the appropriate set,
then continue with step 3 on the next page.
Windows 95 users:
One of two things will happen: Either the “New Hardware Found”
screen will be displayed, or just the Windows 95 desktop will be
displayed.
If “New Hardware Found” is displayed:
Choose “Driver from disk provided by manufacturer,” then click
OK . Insert the HP OfficeJet Series 500 CD into your CD-ROM
drive, or if you have floppy disks, insert Disk #1 into your floppy
drive. Make sure the correct drive is displayed in the dialog box,
for example, “d:” for your CD-ROM drive or “a:” for your floppy
drive. Click
OK . Continue at step 3 below.
If just the Windows 95 desktop is displayed:
Insert the HP OfficeJet Series 500 CD into your CD-ROM drive,
or if you have floppy disks, insert Disk #1 into your floppy drive.
If you’re installing from the CD, the HP OfficeJet Welcome
screen will be displayed after a few seconds. If you’re installing
from a floppy disk, choose
Run from the Start menu in Windows
95, then type:
a:\setup.exe
where “a:” represents the letter of your floppy disk drive. Click
OK . Continue at step 3 on the next page.