HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem User Manual
Page 88
Configuring the Virtual Connect domain using the CLI 88
Virtual Connect Manager not found at this IP address.
If the user attempts to login to the alternate I/O bay, they might receive the error message during the
attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry
again later.
The login should succeed after the Virtual Connect Manager has restarted on this alternate Virtual
Connect Ethernet module. Allow up to 5 minutes, depending on the enclosure configuration.
If the command line option -failover is not included in the reset vcm command or a Virtual Connect
Ethernet module is not available in the alternate I/O bay, the command line displays the message:
SUCCESS: The Virtual Connect Manager is being reset. Please wait...
The user is logged out of the session after approximately 1 minute. If the user attempts to re-login they
might receive the error message during the attempted login:
Unable to communicate with the Virtual Connect Manager. Please retry
again later.
The login should succeed after the Virtual Connect Manager has restarted. Allow up to 5 minutes,
depending on the enclosure configuration.