HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 62)

Command line 62
uplinkport
Manage interconnect module uplink ports.
Supported actions: add, help, remove, set, show
Item Description
add uplinkport Add a new uplink port to an existing network or a shared uplink port set.
Syntax add uplinkport <PortID> [Network=<NetworkName> |
UplinkSet=<UplinkSet>] [Speed=<Auto|10Mb|100Mb|1Gb|Disabled>]
[Role=<Primary|Secondary>]
Parameter
PortID (required) The ID of an uplink port to add (required). The ID is a combination of the enclosure
name, interconnect bay, and port number in a single descriptor. The format of the
port name is "<EnclosureID>:<InterconnectBay>:<PortNumber>".
Properties
Network
(optional)
The name of an existing network to which the port is added
UplinkSet
(optional)
The name of an existing shared uplink port set to which the port is added
Speed (optional) Specifies the port speed for the port (optional). Valid values include "Auto",
"10Mb", "100Mb", "1Gb", and "Disabled". If not specified, the default port speed
is "Auto".
Role (optional) The role played by the port if the connection mode of the network or shared uplink
set is selected as "Failover". The default is "Primary".
Examples
->add uplinkport enc0:1:1 Network=MyNetwork
Adds a new uplink port (Bay 1, Port 1) to a network
->add uplinkport enc0:2:4 Network=MyNetwork Speed=1Gb
Adds a new uplink port (Bay 2, Port 4) to a network and sets the port speed
->add uplinkport enc0:2:3 UplinkSet=MyUplinkSet
Adds a new uplink port (Bay 2, Port 3) to a shared uplink port set
->add uplinkport enc0:2:4 Network=MyNetwork Role=Primary
Adds a new uplink port to a network with the connection mode as Failover and the
port role as Primary
Item Description
remove uplinkport Remove an uplink port element from a network or a shared uplink port set.
Syntax
remove uplinkport <PortID> [Network=<NetworkName> |
UplinkSet=<UplinkSetName>]
Parameters
PortID (required) The name of the port to remove from a network (required). The port name must be in
the following format:
<EnclosureID>:<InterconnectBayNumber>:<PortNumber>
If EnclosureID is not specified, it defaults to the local enclosure.
Network
(optional)
The name of the network from which the port is to be removed