HP Officejet 350 All-in-One Printer - Manual (Page 27)


Selecting Dialing Mode
Dialing Mode offers you an option between Pulse and Tone. In the
Dialing Mode box, choose Tone if your telephone has touch-tone
capability; choose Pulse if it does not. If you select pulse, you may
need to switch from Pulse to Tone to perform certain transactions
like, for example, charging your fax number to a credit card. To
switch from Pulse to Tone, type an asterisk (*) after the fax number.
Note, this feature only works if your Dialing Mode has been set to
Pulse; you cannot switch from Tone to Pulse when dialing. The
example below shows you exactly how this procedure works.
EXAMPLE
To send a fax to the number (111) 222-3333, and then switch to Tone
dialing to enter a credit card number, you would enter the fax number
as 111 222 3333 *. Then enter your credit card number.
You can place the * in Speed Dial entries, Eclipse Fax SE phonebook
entries and numbers you dial from the front panel of the OfficeJet
(for paper faxes) for switching from
Pulse to Tone .
Setting Automatic Redial Option
The factory setting is Automatic Redial=On . With this setting, if the
HP OfficeJet encounters a busy signal, it will redial that fax number
automatically five times (the number varies by country). The first
redial occurs after a 1-minute wait; the next four redials occur after
5-minute waits. During this wait period, the redial timer is displayed
as a countdown. To initiate the next redial without waiting, press the
Redial/Pause button located on the front panel (this applies to paper
faxes only).