HP ProLiant BL20p G3 Server Blade - Manual (Page 89)

Server Blade Troubleshooting
f. iLO initialization
g. Array controller initialization
h. PXE initialization
9. The operating system loads to complete the boot process.
If the server blade completes POST and attempts to load the operating system, refer
to the “Problems After Initial Boot” section in this appendix.
Server Blade Diagnostic Steps
If the server blade does not power up, or powers up but does not complete POST,
answer the questions in Table A-1 to determine appropriate actions based on the
symptoms observed. According to the answers you give, you are directed to the
appropriate table that immediately follows.
Table A-1: Diagnostic Steps
Question Action
Question 1: Is the server blade power
on/standby LED illuminated? If yes, continue to question 2.
If no, refer to Table A-2.
Question 2: Is the server blade power
on/standby LED green? If yes, continue to question 3.
If no, refer to Table A-3.
Question 3: Is the server blade health LED solid
green? If yes, continue to question 4.
If no, refer to Table A-4.
Question 4: Is the iLO remote console
displaying error information? If yes, use the POST messages for further
diagnosis. Refer to Table A-5 for details.
If no, refer to Table A-5.
A-4 HP ProLiant BL20p Generation 3 Server Blade User Guide