HP StorageWorks XP Remote Web Console Software - Manual (Page 82)

82 LUN Manager operations
b. In the iSCSI name list, select the host bus adapter. From the tree, select an iSCSI target, and click
Add iSCSI name.
Figure 41 Add New iSCSI name pane (registering a host that was previously connected to the array)
• In this list, only iSCSI names of hosts that issued login commands to ports appear. Regardless of
the sessions (Discovery or Normal) or results (Accept or Reject), up to 64 iSCSI names of hosts
that recently issued login commands to each port appear. However, if a host issues more than
one instance of the login command to the same port, the host’s iSCSI name appears only once
in the list.
To register iSCSI names using this list and register multiple hosts collectively to one port, you
must register the iSCSI names to the port before the iSCSI names are deleted from this list. If the
iSCSI names are deleted and you want to redisplay the iSCSI names in this list, you must
reissue the login command from the hosts. In this case, you should operate the hosts that need
to log in, and should not add unnecessary iSCSI names to this list.
• If you are using Windows, you can drag the host bus adapter from the iSCSI name table to the
iSCSI target in the tree. To drag two or more host bus adapters, see the HP StorageWorks
Command View XP user guide for XP Disk Arrays or the HP StorageWorks XP Remote Web
Console user guide for XP12000/XP10000/SVS200 for instructions.
c. To assign a nickname to the host bus adapter, enter the nickname in the Nickname box, and click
OK.
NOTE: If you select two or more host bus adapters, Add New iSCSI name panes ( Figure 41 )
appear one after another to let you assign nicknames to the selected HBAs. If you do not need to
assign nicknames to HBAs, you can select The remaining iSCSI names do not need names, and
click OK. If you select this option, the Add New iSCSI name pane ( Figure 41 ) no longer appears to
prompt you to assign nicknames.
If the host has never been connected via a cable to any port in the array, take the following steps:
a. In the tree, right-click the iSCSI target, and select Add New iSCSI name. The Add New iSCSI name
pane appears.
Figure 42 Add New iSCSI name pane (registering a host that has never been connected to the array)
b. In the iSCSI name list, select the host bus adapter. If the list does not include the host bus adapter,
enter the iSCSI name in the iSCSI name box.
c. If necessary, enter a nickname for the host bus adapter.