HP StorageWorks XP Remote Web Console Software - Manual (Page 94)

94 LUN Manager operations
To copy one or more (but not all) LU paths defined to a host group or iSCSI target, complete the
following steps:
a. In the tree, select the host group or iSCSI target.
b. In the LU Path table, select one or more LUNs to which volumes are assigned. (If a volume is
assigned to a LUN, columns on the right of the LUN column are not empty.)
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
d. Double-click the copy destination port to display host groups or iSCSI targets below the port.
e. Right-click the host group to which you want to paste paths, and select Paste Paths. If a
confirmation message appears, click OK.
NOTE: You cannot paste paths to host groups or iSCSI targets for initiator ports.
4. Click Apply. A confirmation message appears.
5. Click OK. Settings are applied to the array.
Copying paths from one NAS port to another
CAUTION: Before taking the following steps, see ” Notes on using LUN Manager ” on page 53 for
important information.
1. Start LUN Manager, and display the LUN Manager pane ( Figure 14 ).
2. To specify the LU paths you want to copy:
a. In the tree, double-click a NAS port (copy source port), and select the User host group.
b. From the LU Path list, select one or more LUNs to which volumes are assigned. If a volume is
assigned to a LUN, columns on the right of the LUN column are not empty.
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
3. To paste the LU paths:
a. In the tree, double-click the copy destination port (NAS port). The User host group appears below
the port.
b. Right-click the User host group, and select Paste Paths.
4. Click Apply. A confirmation message appears.
5. Click OK. Settings are applied to the array.
Copying paths from a Fibre Channel or iSCSI port to a NAS port
CAUTION: Before taking the following steps, see ” Notes on using LUN Manager ” on page 53 for
important information.
1. Start LUN Manager, and display the LUN Manager pane ( Figure 14 or Figure 15 ).
2. To specify the LU paths you want to copy:
a. In the tree, double-click a Fibre Channel or iSCSI port (copy source port), and select a host group
or iSCSI target. The LU Path list displays information about LU paths.
b. In the list, select one or more LUNs to which volumes are assigned. If a volume is assigned to a
LUN, columns on the right of the LUN column are not empty.
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
3. To paste the LU paths:
a. In the tree, double-click a NAS port (copy destination port). The User host group appears below
the port.
b. Right-click the User host group, and select Paste Paths.
4. Click Apply. A confirmation message appears.